5883-XXX SKID PLATE WITH LED EMITTERS FOR JEEP JL & JT
  • 09 Nov 2023
  • 1 Minute to read
  • Contributors
  • Dark
    Light

5883-XXX SKID PLATE WITH LED EMITTERS FOR JEEP JL & JT

  • Dark
    Light

Article summary

LENGTH OF WARRANTY: 

1 Year Warranty

IMPORTANT PRODUCT INFORMATION:

Total Lumens: 9000Lm

Total Wattage: 135w

Total Amp Draw: 6a

FITMENT INFORMATION: 

  • Currently the only known potential obstruction for fitment pertains to bumper/winch combos, as most winches require support brackets “Winch Plates” to be mounted to the frame. The bolts for these plates can hit the end-most lights on the Skid Plate, causing it to not fit. 

  • Using a spacer between ½” & ¾” on both bolts behind the Skid Plate should provide enough clearance for the Winch Plate Bolts while maintaining sufficient protection for the Sway Bar. 

  • For reference, here is a link to the type of spacers needed- https://www.lowes.com/pd/Hillman-3-8-in-x-1-2-in-x-1-in-Seamless-Steel-Spacer/3012477

  • Any other fitment anomalies or modifications needed pertaining to an aftermarket bumper should be done at the customer’s discretion & measurements / mock-ups should be done prior to install. 

INSTALL DOCUMENTATION:

PDF: https://cdn.shopify.com/s/files/1/1766/0599/files/ORACLE_5883_Install_Guide.pdf?v=1633020150

Diagram - For Normal Switch Harness Installation:

Diagram - For OEM AUX or Aftermarket Up-Fitter Switch Installation:

TROUBLESHOOTING: 

  • Lights Not Powering On

    • Check to see if indicator LED on the included switch is illuminated - If not illuminating, check connections to battery & check fuse to ensure not blown.

    • If indicator LED is illuminated & the lights do not power on - Check cables from relay to lights for any damage, check plugs to lights are secured. 

  • Condensation / Moisture

    • There is a screw valve on each (6) Light Emitter(s) that can be loosened to allow condensation to outgas

    • Follow standard condensation vs ingress guidelines

  • 1 or More of 9 Light Emitters Not Powering On 

    • Switch the non-functioning Light Emitter's plug with a functioning one's plug at the back of the assembly

    • If the Light Emitter still does not power on - Follow standard photo warranty guidelines

    • White Light Emitter PN# 5893-001

    • Yellow Light Emitter PN# 5821-006

    • Switch cable too short?

      • You can relocate relay to LH (Driver) side & extend the Red (Power) & Black (Ground) wire to the battery

        Does fuse blows each time the switch is powered ON ?

      • This is commonly due to the outer plug being smashed against the frame. Care must be taken to make sure the connector is clear of the frame rail before tightening down the bolts. See picture below

      •  

        You can do the following:

        Cut the connector off and connect the two Red Wires & the two Black Wires together

        We can replace the harness at no charge PN# 5883-LTH - Customer must cover shipping



Was this article helpful?