5890-XXX Bronco Triple LED Foglight Kit

LENGTH OF WARRANTY: 

IMPORTANT PRODUCT INFORMATION:

• Offered in White (5890-001) and Yellow (5890-006)

  6000 Raw Lumen Output

• Total Wattage: 90w (45w per side)

  Total Amp Draw: 3.6A

INSTALL DOCUMENTATION:

Diagram - For Normal Switch Harness Installation:

Diagram - For OEM AUX or Aftermarket Up-Fitter Switch Installation:

FITMENT INFORMATION: 

Fits Steel Mod Bumper ONLY
TROUBLESHOOTING / KNOWN ISSUES: 

• Fuse Blowing When 1 or Both Foglights Plugged In

  • There has been an issue found linked to a short in the harness that chains the 3 LED emitters together - please contact customer support.

• Lights Not Powering On (only when using our harness) 

• Check to see if indicator LED on the included switch is illuminated - If not illuminating, check connections to battery & check fuse to ensure not blown.
  If indicator LED is illuminated & the lights do not power on - Check cables from relay to lights for any damage, check plugs to lights are secured. 

1x Side of Lights Not Powering (Aftermarket Aux Switch) 

• Move the non working fog or harness side to the working side 

• If the light comes on then the issue is with the side of the harness 

• Check the polarity of the pins in the harness 

  You may need to de-pin the harness and reposition pins to match the harness connector

  Instructions are not provided since this is their aftermarket harness 

  Suggestion is to always use the harness that is included 

• If the lights still dont come on, contact customer service.

• Condensation / Moisture

There is a screw valve on each (6) Light Emitter(s) that can be loosened to allow condensation to outgas

• If it was just after power washing or submersion this will likely clear

1 or More of 6 Light Emitters Not Powering On 

• Switch the non-functioning Light Emitter's plug with a functioning one's plug at the back of the assembly

• If the Light Emitter still does not power on - Follow standard photo warranty guidelines

• White Light Emitter PN# 5893-001

• Yellow Light Emitter PN# 5821-006

• if wanting to use the Fog Lights as true "fog lights" with one LED emitter per side: We don't sell a harness or have a wiring guide for this, but instead of cutting anything and voiding your warranty, purchase 6x 2 pin adapters. Doing so, you would then be able to plug one extension into each individual light then cut the other end off and strip the wires back. Then you would hard wire the 4 that you want together on one AUX switch and then the remaining 2 would be hard wired together to the other AUX switch. Also, keep in mind that AUX switches send power only so you would need to put all the grounds either to chassis or to battery negative.

• If the fog lights are aiming high and are not operating as a fog light - If you continue to get flashed running white a simple washer can be added to the 2 lower mounts on the projector to change the angle enough to correct this. May be necessary on Broncos with lifts or with "leveling" kits especially.