Pre-Runner Style LED Grill Light Kit

Length of Warranty:

1-year

Important Product Information:

Here are some key details about our product:

• If you're using the Pre-Runner kit with a Gladiator, you'll receive washers needed for the installation.

• Please note that the connections are not waterproof, but you can apply di-electric grease to prevent corrosion.

• Some customers ask if they can use the kit with a JK grill. As is, the Pre-Runner kit won't fit a JK grill. Any modifications would be up to the customer's initiative, and we don't offer specific suggestions. Once attempted, we can't accept returns as a result of these modifications.

• If you're considering using the kit with a trail camera, you should mount it in the middle of the grill, further down. While it might not achieve the intended appearance, it will still work.

Fitment Information:

For Gladiator fitment, please be aware that the nut will not be large enough to pass through the plug. You'll need to de-pin the plug to remove the nut, allowing the cable to pass through the included washers. You can find a video tutorial on how to de-pin and re-pin here: De-Pin Video and Re-Pin Video.

Wiring Information:

A few wiring details to keep in mind:

• The fender DRL wire cannot be used as a power source.

• Tapping into the parking lights will give you manual control over the LED accessory during daytime driving, and setting it to AUTO mode will make the LED accessory come on automatically in night mode.

• If you want the LEDs on all the time, you can connect them to the F52 fuse in the engine compartment fuse panel.

You can refer to the installation videos and guides for Jeep JL and JT models to help with the wiring:

• JL Install Video & JL Install Guide

• JT Install Video & JT Install Guide

Troubleshooting:

In case you face any issues, we've got you covered:

• If you encounter moisture, don't worry; it's covered under our one-time warranty with replacements. Just reach out to us.

• If you notice spacers that appear orange or rusted, you can replace only the washer (spacers) without needing to replace the entire kit. Process part #30-MM-SPACER, and you only need to order the quantity required. Customers will cover the shipping cost, and we can provide a quote for 1st Class shipping through PayPal.

• If you report that one or more LEDs are out, we recommend checking all connections for corrosion. You can also test by moving the cable at the base of the billet while it's powered on to see if there's any change in the light (like flickering). If you find an issue, we'll replace it as part of our photo warranty.